Expert Answers about Toyota Corolla iM

• Where Can Tow Bar Wire be Grounded With Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
• It is always preferable to attach the ground directly to the chassis frame, and where you can safely ground the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267 depends on if the owner's manual of your 2018 Toyota Corolla iM specifies a location that you need to attach the ground wire. I cut out a portion of the installation instructions of this kit for you to check out and as you can see it is possible you may need to attach the ground wire at a specific spot to avoid...
  view full answer...


• Carrying Bikes And Hatch Clearance On A 2018 Toyota Corolla iM
• Unfortunately when any trunk mounted bike rack, including the Malone Runway Trunk Bike Rack for 3 Bikes - Adjustable Arms. part # MPG2142, is on a vehicle loaded with bikes you will lose access to the trunk/hatch of that vehicle. You can access the trunk of your vehicle if you went with a hitch offering instead. For a hitch receiver, I recommend the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4", part 24913. It is 1 1/4" Class I hitch receiver with a maximum...
  view full answer...


• Power Switch Light of Camco Propane to Electricity Converter On When Switch is Off
• I reached out to a representative of Camco who said the switch light of the Camco Propane to Electricity Converter for 6-Gallon RV Water Heaters # CAM11673 is likely on because you may not have a good ground. Additionally, they said sometimes the ground and neutral get wired together which can also cause this to happen but the reason is likely going to be an issue with a poor ground.
  view full answer...


• Does the Reed Switch Eliminate the Brake Light Switch on an SMI Braking System
• According to the installation instructions for the SMI Air Force One Supplemental Braking System for Motor Homes with Air Brakes part # SM99243, the reed switch attached to the actuator will power the LED. The brake switch will no longer be providing the signal for the monitor light. Exercise caution when installing the reed switch. If the reed switch arcs to ground, it will either no longer work or cause the LED to stay illuminated at all times. You can reference the installation of the...
  view full answer...